Endress+Hauser Proline Promag W 400 - Page 57

Proline Promag W 400 System integration
Endress+Hauser 57
Possible input values
Possible input values 1 to 10:
• Off
• Mass flow
• Volume flow
• Corrected volume flow
• Target mass flow
• Carrier mass flow
• Density
• Reference density
• Concentration
• Temperature
• Carrier pipe temperature
• Electronic temperature
• Oscillation frequency 0
• Oscillation frequency 1
• Oscillation amplitude 0
• Oscillation amplitude 1
• Oscillation frequency 0
• Oscillation frequency 1
• Oscillation damping 0
• Oscillation damping 1
• Signal shift
• Tube damping fluctuation 0
• Tube damping fluctuation 1
• Exciter current 0
• Exciter current 1
• Monitoring of exciter current 0
• Monitoring of exciter current 1
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Sensor integrity
Possible input values 11 to 20:
• Off
• Current diagnosis
• Previous diagnosis
• Mass flow unit
• Volume flow unit
• Corrected volume flow unit
• Temperature unit
• Density unit
• Reference density unit
• Concentration unit
• Current unit
• Status verification
• Totalizer 1 unit
• Totalizer 2 unit
• Totalizer 3 unit
• Verification result
Permanently assigned output group
Output Assembly Fix (Assem102) 64 byte
Designation Description (format) Byte Bit Value
Output
Assembly Fix
1. Totalizer 1 1 1
• 0: Enable
• 1: Disable
2. Totalizer 2 2
3. Totalizer 3 3
4. Pressure compensation 4
5. Reference density compensation 5
6. Temperature compensation 6
7. Verification 7
8. Not used 8 –
9. Not used 2…4 0…8 –
10. Control totalizer 1 (integer) 5…6 0…8 • 32226: Add
• 32490: Reset and stop
• 32228: Default value and stop
• 198: Reset and add
• 199: Default value and add
11. Not used 7…8 0…8 –