Installation Proline Prowirl 73
14 Endress+Hauser
2.4 Post-installation check
• Is the measuring device damaged (visual inspection)?
• Does the measuring device correspond to the specifications at the measuring point?
• Is the serial number of sensor and the connected transmitter the same?
• Are the measuring point number and labeling correct (visual inspection)?
• Correct internal diameter and correct surface roughness/quality?
• Sensor orientation correctly selected in terms of type, fluid properties and fluid temperature?
• Does the arrow on the sensor point in the direction of flow in the pipe?
• Is the measuring device protected against moisture and direct sunlight?
• Is the measuring device protected against overheating?
To Next Page
Loading...
