Endress+Hauser Proline Prowirl R 200 - Page 43

Proline Prowirl R 200 Operation options
Endress+Hauser 43
8.2.1 Operational display
Status area
Status signals
A0013956 A0013959 A0013958 A0013957
Failure Function check Out of specification Maintenance required
Diagnostic behavior Locking Communication
A0013961 A0013962
A0013963
A0013965
Alarm Warning Device locked Remote operation enabled
Display area
Measured variables
Symbol Meaning
A0013711
Volume flow
A0013943
Totalizer
The measurement channel number indicates which of the three totalizers is
displayed.
A0013945
Output
The measurement channel number indicates which of the two current outputs is
displayed.
Symbols for measurement channel numbers
A0016325
Measurement channel 1 to 4
The measurement channel number is displayed only if more than one channel is present for the same
measured variable type (e.g. Totalizer 1 to 3).
Symbols for diagnostic behavior
The diagnostic behavior pertains to a diagnostic event that is relevant to the displayed measured variable.
For more information about the symbols, refer to the "Status area" section
(→  43)
8.2.2 Navigation view
Status area
The following appears in the status area of the navigation view in the top right corner:
•
Of the submenu
– The direct access code for the parameter you are navigating to (e.g. 0022-1)
– If a diagnostic event is present, the diagnostic behavior and status signal
• In the wizard
If a diagnostic event is present, the diagnostic behavior and status signal