Endress+Hauser Proline t-mass 65 - Certificates and Approvals; Registered Trademarks

Installation Proline t-mass 65
10 Endress+Hauser
Aligning to flow direction
Aligning to pipe
!
Note!
The sensor cannot automatically detect the flow direction. These specifications only ensure that
the device is installed and aligned correctly.
2.2.9 Insertion version with low-pressure mounting set
Installation instructions for the insertion version with low-pressure mounting set
→ see Operating Instructions on the CD-ROM.
2.2.10 Temperature range
Install the sensor away from direct sunlight and extremes of temperature.
A0007536
The arrows on either side of the transmitter housing must
point in the direction of flow.
The graduated scale on the insert pipe must point to the
flow inlet side.
A0007537
Weld the welding nozzle onto the pipeline or duct. Align
the sensor (sensing element) at a 90 ° angle to the
direction of flow.
90°
90°