Endress+Hauser Proline t-mass 65 - Commissioning; Switching on the Measuring Device

Proline t-mass 65 Commissionin
g
Endress+Hauser 21
5 Commissioning
5.1 Switching on the measuring device
On completion of the installation (successful post-installation check), wiring (successful
post-connection check) and after making the necessary hardware settings, where applicable, the
permitted power supply (see nameplate) can be switched on for the measuring device.
W
hen the power supply is switched on, the measuring device performs a number of power-up
checks and device self-checks. As this procedure progresses the following messages can appear
on the local display:
The measuring device starts operating as soon as the startup procedure is complete.
Various measured values and/or status variables appear on the display.
!
Note!
If an error occurs during startup, this is displayed by an error message. The error messages that
occur most frequently when a measuring device is commissioned are described in the
Troubleshooting section → Page 26.
Display examples:
Name of the measuring device
START-UP
RUNNING
Start-up message
Æ
Name of the measuring device
DEVICE SOFTWARE
V XX.XX.XX
Displays the current software
Æ
SYSTEM OK
→ OPERATION
Beginning of operation