3.4 Mounting the sensor
Mounting Promag 30 A
Length and dimensions
See chapter 7.1 “Dimensions and weights”.
Mounting
The inserted parts are
• screwed on to the 1" stub with a skirted nut.
• mounted instead of the 1" threaded stub.
Screw tightening torques and gaskets
When screwing on the inserted parts the O-ring or the flat gasket is pressed
completely into the sealing groove of the stub. The skirted nut thereby experiences a
fixed stop.
3. Mounting and Installation
Sensor 1" threaded stub (ISO 228):
not required with flange joints
O-ring of Viton or Kalrez or silicone flat gasket
(aseptic) version
Nominal
diameters:
DN 2...25
ba008y15
Internal thread, external thread, PVC adhesive
coupling, hose connection and welded nipples,
are screwed on with a skirted nut
Tri-clamp
®
connection are
fitted instead of the
threaded stub.
Flange joints
(stainless steel 1.4404/316L,
PVDF) are fitted instead of the
threaded stub
Fig. 17
3. Mounting and Installation Promag 30
18 Endress+Hauser
To Next Page
Loading...
