1. Safety Instructions
1.1 Correct Usage
• The Promag 30 is only to be used for measuring the flow of conductive fluids.
• The manufacturer assumes no liability for damage caused by incorrect use of the
instrument.
1.2 Dangers and Notes
All instruments are designed to meet state-of-the-art safety requirements, have been
tested, and have left the works in an operationally perfectly safe condition. The
devices were developed according to EN 61010 “Protection Measures for Electronic
Equipment for Measurement, Control, Regulation and Laboratory Procedures”.
A hazardous situation may occur if the flowmeter is not used for the purpose it was
designed for or is used incorrectly. Please carefully note the information provided in
this Operating Manual indicated by the pictograms:
Warning!
A “warning” indicated actions or procedures which, if not performed correctly, may
lead to personal injury or a safety hazard.
Please strictly observe the instructions supplied and proceed carefully.
Caution!
A “caution” indicates actions or procedures which, if not performed correctly, may
lead to faulty operations or the destruction of the instrument.
Please strictly observe the respective instructions.
Note!
A “note” indicates actions or procedures which, if not performed correctly, may
indirectly affect operations or lead to an unexpected instrument response.
Warning!
Promag 30 1. Safety Instructions
Endress+Hauser 5
To Next Page
Loading...
