Endress+Hauser Prosonic T FMU30 - Wiring and Electrical Setup; Electrical Connections

Wiring Prosonic T
16 Endress+Hauser
4 Wiring
4.1 Electrical connection
"
Caution!
Before connection please note the following:
• The power supply must be identical to the data on the nameplate.
• Switch off power supply before connecting up the instrument.
• Connect equipotential bonding to devices ground terminal before connecting up the instrument
 ä 18, "Potential matching".
#
Warning!
When you use the measuring system in hazardous areas, make sure to comply with national
standards and the specifications in the safety instructions (XA’s). Make sure you use the specified
cable gland.
4.1.1 Wiring
1. Unscrew housing cover (1).
2. Remove display (2) if fitted.
3. Insert cable (3) through gland (4).
"
Caution!
If possible, insert the cable from above and
let a draining loop in order to avoid
intrusion of humidity.
4. Installation cable screen to the grounding
terminal (5) within the terminal
compartment.
5. Make connection according to terminal
assignment,  ä 17, "Terminal
assignment".
6. Tighten cable gland (4).
7. Insert display (2) if fitted.
8. Screw on housing cover (1).
9. Switch on power supply.
L00-FMU30xxx-04-00-00-xx-008
1
2
1
2
3
5
4