Prosonic T Commissioning
Endress+Hauser 27
6 Commissioning
Commission the device in the following stages:
• Installation check
• Power-up device
• Basic calibration
• Measuring signal check using the envelope curve
The chapter describes the commissioning process using the on-site display. Commissioning using
FieldCare operating program is identical.
6.1 Power up instrument
After switching on the supply voltage, the instrument is first initialised.
Then the following appear for approximately five seconds:
• Device type
•Software version
Press E to exit this display.
On first power-up, you are requested to select
the language for the display texts. Available
language:
• English
•Deutsch
• Français
•Español
• Italiano
• Nederlands
• Japanese
L00-fmrxf092-20-00-00-en-001
Then you are requested to select the unit of
length for your measurements. Available unit of
length:
•m
•ft
•mm
•inch
L00-fmrxf0c5-20-00-00-en-001
A measured value is displayed. This is NOT
equivalent to the level in your tank. Firstly carry
out a basic calibration.
L00-fmrxf000-20-00-00-en-001
Press E to switch to the group selection.
Press E again to start the basic calibration.
L00-fmrxfg00-20-00-00-en-001
To Next Page
Loading...
