Endress+Hauser Prosonic T FMU30 - Page 35

Prosonic T Commissioning
Endress+Hauser 35
Horizontal Zoom mode
Firstly, go into the envelope curve display. Then press + or - to switch to the envelope curve
navigation. You are then in Horizontal Zoom mode. Either or is displayed.
• + increases the horizontal scale.
• - reduces the horizontal scale.
L00-FMU3xxxx-07-00-00-xx-007
Move mode
Then press E to switch to Move mode. Either or is displayed.
•+ shifts the curve to the right.
• - shifts the curve to the left.
L00-FMU3xxxx-07-00-00-xx-008
Vertical Zoom mode
Press E once more to switch to Vertical Zoom mode. is displayed. You now have the following
options.
• + increases the vertical scale.
• - reduces the vertical scale.
The display icon shows the current zoom factor ( to ).
L00-FMU3xxxx-07-00-00-xx-009
Exiting the navigation
• Press E again to run through the different modes of the envelope curve navigation.
• Press + and - to exit the navigation. The set increases and shifts are retained. Only when you
reactivate the "recording curve" (0E2) function the display settings return to their standard
values.