Endress+Hauser Prosonic T FMU30 - Page 45

Prosonic T Accessories
Endress+Hauser 45
Cantilever
A0019349
• The 50 mm (2.17 in) or 62 mm (2.44 in) orifices serve for the mounting of the 1½" or 2" sensor,
respecitvely.
• The 22 mm (0.87 in) orifice may be used for an additional sensor.
For the mounting of the cantilever can be used:
• mounting frame  ä 46
• wall bracket  ä 46
A B C D for Sensor Material Order Code
585 (23) 250 (9.84) 2 (0.08) 200 (7.87) 1½" 316Ti (1.4571) 52014132
galv. steel 52014131
2" 316Ti (1.4571) 52014136
galv. steel 52014135
1085 (42.7) 750 (29.5) 3 (0.12) 300 (11.8) 1½" 316Ti (1.4571) 52014134
galv. steel 52014133
2" 316Ti (1.4571) 52014138
galv. steel 52014137
mm (in)
A
D
M8
35 (1.4)
50 (2.0)
20 (0.8)
105 (4.1)
50/62
(2.0/2.4)
22 (0.9)
C
C
6.5 (0.3)
15 (0.6)
100 (3.9)
25 (1.0)
35 (1.4)
100 (3.9)75 (2.9)
B
20 (0.8)
75 (2.9)
mm (in)