RIA15 Commissioning
Endress+Hauser 37
Expert menu (EXPRT); a code must be entered
In addition to all the parameters in the Setup menu, the Expert menu also contains the parameters
described in this table. If you call up the Expert menu, you will be asked to enter the user code (UCODE,
default: 0000).
Parameters Values visible at Description
LEVEL MODE =
HART
This menu contains the parameters for
configuring the FMR20 level transmitter.
The Level menu and all the related submenus
are only visible if the RIA15 has been ordered
with the "FMR20 basic configuration" option. The
basic settings can be made at the Micropilot
FMR20 radar level sensor via the RIA15 using
this menu. Description of the individual
parameters → 40
SYSTM
UCODE Numerical value 0000
to 9999
Default: 0000
4-digit user code
With the user code it is possible to protect the
device setup from unauthorized modifications. If
the setup is disabled, a padlock symbol appears
on the display when an operating parameter is
selected.
The user code is not active with the default
setting "0000". This means that setup parameters
can be changed without entering the code. The
code must always be entered for the Expert
menu, even for the default setting.
FRSET NO
YES
Resets the device setup. The values are reset to
the preset values for preconfigured devices, and
to the default values for all other devices. Select
"YES" and press "E" by way of confirmation to
reset the device.
TOGTM 5
10
15
20
MODE =
HART
Use this function to select the switching time in
seconds between HART® values if "AUTO" was
selected in the DISP1-DISP4 menu.
INPUT The following parameters are available in
addition to the parameters from the Setup menu.
To Next Page
Loading...
