Endress+Hauser Soliwave FDR56 - Page 24

Soliwave FDR56/FQR56
24 Endress+Hauser
Commissioning
Move the encoding switch to the initial position 0
→ Display of the current signal strength
• A larger hysteresis can also be used to prevent the output from continuously switching with
a uctuating signal strength. If, for example, the signal strength continuously uctuates
between the third and eighth LED, the factory default hysteresis of an LED would lead to the
switch output continuously switching when the fourth LED is undershot.
• This setting has no signicance for the current output.
7.3.2 Limit signal function (function 6)
For devices with a relay and solid-state relay, the limit signal function determines the swit-
ching behavior upon exceeding and undershooting the limit value (upper limit value LED 5,
lower limit determined by hysteresis).
A
A
B
C
0000000295
15 Adjustmentoflimitsignalfunction
A Restposition(supplyvoltagemissing)
B Minimumsafety
C Maximumsafety(defaultsetting)
Move the encoding switch to position 6
→ Display of the function number
→ Aer 2 seconds: Display of the congured limit signal function, example:
Press the button on the device in order to change between the two possible limit signal
functions
→ Display of the changed limit signal function, example:
Move the encoding switch to the initial position 0
→ Display of the current signal strength