Endress+Hauser Soliwave FDR56 - Basic Safety Instructions; Requirements for the Personnel; Designated Use

Soliwave FDR56/FQR56
Endress+Hauser 5
Basic safety instructions
1.1.5 Device-specic symbols
LED on
Indicates an illuminated LED
LED o
Indicates a non-illuminated LED
Conguration mode
Indicates the function number or value
Normal operation
Indicates only the signal strength of the limit detection
Key (+)
Indicates the key for increasing a function value
Key (-)
Indicates the key for reducing a function value
Free path
Indicates the free path between FDR and FQR
Covered path
Indicates the covered path between FDR and FQR
2 Basic safety instructions
2.1 Requirements for the personnel
The personnel must fulll the following requirements to carry out the necessary tasks, e. g.,
commissioning and maintenance:
‣ Trained, qualied specialists must have a relevant qualication for the specic function and
task
‣ Are authorized by the plant owner/operator
‣ Are familiar with federal/national regulations
‣ Must have read and understood the instructions in the manual and supplementary docu-
mentation
‣ Follow instructions and comply with conditions
2.2 Designated use
Use the microwave barrier only for point level detection and counting and control purposes.
Improper use can pose hazards. Ensure that the measuring device is free of defects while it is
in operation.
• Use the measuring device only for media to which the process-wetted materials have an
adequate level of resistance
• Do not exceed or drop below the limit values for the measuring device
 TI00443F