Soliwave FDR56/FQR56
6 Endress+Hauser
Incoming acceptance and product identication
2.2.1 Incorrect use
The manufacturer is not liable for damage caused by improper or non-designated use.
Clarication of borderline cases:
• In the case of special uids and media used for cleaning, Endress+Hauser is glad to provide
assistance in verifying the corrosion resistance of wetted materials, but does not accept any
warranty or liability.
Residual risks
The electronics housing and the modules installed in it can heat up to 80°C (176°F) during
operation due to heat input from the process as well as the power dissipation of the electro-
nics.
Danger of burns from contact with surfaces!
‣ If necessary, ensure protection against contact to prevent burns.
2.3 Workplace safety
For work on and with the device:
‣ Wear the required protective equipment according to federal/national regulations.
2.4 Operational safety
Risk of injury!
‣ Operate the device in proper technical condition and fail-safe condition only.
‣ The operator is responsible for interference-free operation of the device.
2.5 Product safety
The devices of the microwave barrier are designed in accordance with good engineering
practice to meet state-of-the-art safety requirements, has been tested, and le the factory in a
condition in which it is safe to operate.
They meet general safety standards and legal requirements. They also complies with the EU
directives listed in the device-specic EU Declaration of Conformity. Endress+Hauser conrms
this by axing the CE mark to the devices.
3 Incoming acceptance and product identication
3.1 Incoming acceptance
Check the following during goods acceptance:
Are the order codes on the delivery note and the product sticker identical?
Are the goods undamaged?
Do the nameplate data match the ordering information on the delivery note?
If required (see nameplate): Are the Safety Instructions, e. g. XA, provided?
Is the device properly secured?
To Next Page
Loading...
