Engcon C2C - Table of Contents

Table of Contents
Table of Contents
1. Introduction
1.1. General............................................................................................................ 4
1.2. Scrapping and recycling.................................................................................. 4
1.3. Technical support and spare parts.................................................................. 4
2. Safety
2.1. General............................................................................................................ 5
3. Installation
3.1. System overview............................................................................................. 6
3.2. Electronics....................................................................................................... 7
3.2.1. A: Connecting C2C with cabling X31 V2................................................. 8
3.2.2. B: Connecting C2C with cable 842174....................................................9
4. Configuration
4.1. Update software in DC2..................................................................................10
4.2. Check the ePS sensor versions......................................................................11
4.3. Updating C2C software................................................................................... 11
4.4. Configuration ePS........................................................................................... 15
4.4.1. Unlock the engcon Positioning system (ePS)..........................................15
4.4.2. Overview - ePS v1...................................................................................16
4.4.3. Overview - ePS v2...................................................................................17
4.4.4. Configuring ePSv2................................................................................... 18
4.4.5. Select buttons on the grip....................................................................... 19
4.4.6. Configure ePS v2 sensors.......................................................................20
5. On completion
5.1. Documenting the installation........................................................................... 21
6. Troubleshooting
6.1. C2C..................................................................................................................22
6.1.1. Alarm overview........................................................................................ 22
6.1.2. Indications................................................................................................ 22
6.2. Troubleshooting table...................................................................................... 24
7. Technical data
7.1. Electronics module C2C..................................................................................27
7.2. Connector overview.........................................................................................27
3