Engcon DC2 QSC - 5.4. Wheel Control Activation; 5.5. Track Control Activation; 5.6. Switching User Profiles

5 Operation
5.4. Wheel control
WARNING
When wheel control is active, speed should not
exceed 20 km/h.
Press the activation switch to switch on wheel control.
Operate wheel control using the roller that was configured upon
installation.
5.5. Track control
Press the activation switch to switch on track control.
Operate track control using the roller that was configured upon
installation.
5.6. Switching users
Use button SW7 to switch users from User 1 to Shear.
1. Depress and hold down button SW7 for at least 3 seconds until the cabin module
beeps.
2. When the signal ceases, the user switch is completed.
SW7
37