EnGenius DuraFon PRO - Basic Base Station Features; Antenna, Jacks, Indicators, Registration, Reset

20
Basic Base Station Features
1.
Antenna
a.
The antenna port has a reverse thread connector; to remove
antenna or cable, turn clockwise; to install, turn counterclockwise.
Improper installation may damage the connector
b.
When using an outdoor antenna, locate the antenna (not the base
station itself) as high as possible for a clear transmission path.
2.
Audio-in Jack (3.5mm)
3.
Line Status LED
Indicates an active telephone line.
4.
Power LED
Indicates base station has power.
5.
L1 – L4
Standard RJ-11C/CA-11A connector to plug in the telephone line
6.
DC In Jack
Jack for AC power adapter
Re：The AC power adapter is 100~240VAC/12VDC, do not use other non-
compatible AC, in case any damage or safety issue.
7.
Registration Key (REG)
Enters registration mode along with handset, assigns handset ID (10-90).
8.
Reset Button
a.
Restores base station to factory settings
b.
Reset button is indented to prevent accidental system reset.
c.
All handsets (including administrator) and additional base(s) need to
be re-registered after a base station reset.
9.
Grounding jack
Connecting with grounding wire
10.
Console jack
Jack for firmware upgrade (Type-B USB connector)
Re:
Please consult with EnGenius Tech support about the firmware
upgrade.