EnGenius DuraFon PRO - Charger Features; Charging Slots and Indicators

23
Charger Features
1.
DC In
Connects to Charger AC Adaptor.
2.
Handset Charging Slot
a.
Charge handset battery when handset is placed in cradle.
b.
Refer to the handset LCD for charging status
(1)
Charging: LCD screen showed “Charging”
(2)
Fully Charged: battery status bar stands still and the LCD screen
would display “Fully Charged”
(3)
Charge Fail: Should an error occur during charging mode, the LCD
screen would display “Charge Fail”
3.
Spare Battery Charging Slot
a.
Charge spare battery when battery is placed in slot.
b.
LED as the spare battery charging indicator
(1)
Slot is empty and the power is on: LED is Green light
(2)
Charging: LED is Orange light
(3)
Fully Charged: LED returns to Green light
4.
It is impossible to overcharge the battery using this charger.
5.
The adaptor for charging station can be used as travel charger as well.
However, you cannot turn off the power while charging with the travel
charger. A Warning message: “Unplug Travel Chgr then OFF” will be shown
on the LCD display.
Notes:
I. Fully charge battery packs before first use.
II. Both handset and spare batteries can be charged at the same time.
III. Handset will be “power on” automatically when placing on the
charging slot.
IV. However, if you run down the battery, it will take around one
minute for handset to auto power on.