EnGenius DuraFon PRO - Advanced Call Handling; Call Hold, Mute, and Do Not Disturb

36
Placing a Call On Hold (For DuraFon PRO only)
1.
When a call is in progress, it can be put on hold by pressing the
HOLD (Right) soft key.
2.
To return to the conversation, press “UNHOLD”
Notes:
1. The call being placed on hold can only be removed from HOLD by the
handset that puts it on hold.
2. Handset LCD displays a call is being on hold. An alert tone (double
beep) every 30 seconds will remind the handset that a call is being on
hold.
3. If the operation (e.g., call transfer) after putting a call on-hold fails, the
held call may be dropped.
4. You can power off the handset (e.g., change battery) while call is on
hold. After power on again, you can continue the call by pressing
UNHOLD (Left) soft key or select “3” from the Option menu to
terminate the hold state.
5. You can only unhold the call when within the coverage area of the
base. Once you’re out of the base coverage, you can return to stand-
by using “Clear hold” function in the OPTION list item #3.
Mute
1.
After a link is established, you can press OPTION (Left) soft key and
press 0 to mute the handset microphone.
2.
When mute is active, the other party will not hear your voice, but
you can still hear the other party.
3.
To end the mute, press OPTION (Left) soft key and press 0 to
unmute the handset microphone.
Re: If established an intercom call, when end the mute, press
UNMUTE (Left) soft key.
Do Not Disturb (Silent Ring)
1.
Enter the key sequence MENU  4.Sounds  1.Ring Volume, then