Additional Base Station Features
4 Auto-Attendant can be active at the same time in case of 4
simultaneous incoming calls.
Allows private paging to a single handset (with individual Handset ID) or
group paging to a group of handsets (with Group ID).
Per line AA enable/disable by administrator. When disabled for a line,
the administrator can set all handsets to ring with an incoming call on
that line, or a particular Handset/Group ID (either one; not
simultaneously) can be assigned to have incoming call privileges on that
line. See AA Configuration by Administrator
Up to 120 seconds customizable main greeting message.
Default of 4 lines AA is OFF.
Optional Outdoor Antenna Kit with cable.
Administrator Features
Handsets 10 and 11 are designated administrators. Both have the same authority
to perform base station administrative functions from their handset menu
selections. No password is required.
Supports both DTMF and Pulse dialing(For DuraFon PRO only)
From an administrator handset (Handset 10 or 11 ), press MENU- 9 – 1 –
enter base ID(00–07)- 1 to select Tone or Pulse dialing mode.
Administrator programmable Flash key timing(For DuraFon PRO only)
From an administrator handset (Handset 10 or 11), press MENU- 9 -1-2 to
select flash key timing
9-level (100 ms - 900 ms) timing selections, default= 600 ms.
The default value (600 ms) works in most areas. Changing this setting may
result in Flash function not working. Change only when you are certain
the new value will work.
Call Transfer to PBX Extension(For DuraFon PRO only)
When the DuraFon PRO is installed behind a PBX system, you can pre-
program the feature code of call transfer function.
Need to adjust the Flash time to match your PBX setting.
If loosing administrator handsets (handset 10 and 11), all settings must be
reset (reset the base and re-register all handsets).
To Next Page
Loading...
