EnGenius DuraFon PRO - Call Management and Reception; Redial, Receiving Calls, and Ending Calls

34
The broadcast will be over once user release the key.
2. You need to notice that there is no bi-bi-beep sound when receiving a
broadcast.
3. You can press the SILENT (Left) soft key if you choose to ignore the call.
The SILENT key operation is valid only for the current call. You can silent
all broadcast by turning off the ringer to set auto-silence from the
handset menu.
Redial (For DuraFon PRO only)
1.
Press REDIAL (Left) soft key.
2.
The LCD shows the last phone number dialed. To dial this number, press DIAL
(Left) soft key.
3.
Use or Key to scroll through the last 10 phone numbers dialed.
Select and press DIAL key.
Note: Intercom numbers (Handset ID) are not stored in the last 10 numbers
dialed log.
Receiving a Telephone Call (For DuraFon PRO only)
1.
When an incoming call arrives, the handset will ring or vibrate unless the ringer
has been turned off.
2.
If the handset is on the charger cradle (ringer will be temporarily switched to
“Ring” if it has been set to “Vibrate”), lift the handset and start the
conversation.
3.
If the handset is not on the cradle, press any key (except , and the SILENT
soft key) to answer.
4.
During the call, press and hold the key, the speakerphone is active.
Notes:
1. You can press SILENT (Left) soft key if you choose to ignore the call.
Unlike turning off the ringer (from the handset menu), the SILENT
key operation is valid only for the current call.
2. If Caller ID service is available, the LCD will display the incoming call
information. If the LCD shows “Private” or “Unknown”, the caller’s