EnGenius DuraFon PRO - Call Waiting Features; DuraFon PRO Built-in Call Waiting

44
4.
Press number 3 , handset enters Base Select setting mode.
5
Use or arrow to scroll up and down the selection
on/Off.
6.
Make a selection (default =off), and press SAVE (Left soft key).
Re: When turns on the Base Select, you must enter 2-digit Base ID
after press key.
Notes:
1. Because this setting allows handset manually select the base station, the
handset must be in range with the direct base station.
Call Waiting (For DuraFon PRO only)
1. A handset, while talking on one phone line, can be informed of the arrival of a
new incoming phone call.
2. For example, suppose that Handset 15 is talking on Line 1. When a new call
comes in on, Line 4, and the caller enters extension number “15” when
prompted by the AA, or if the call is set to be routed to Handset 15 when AA is
disabled.
3. The base station recognizes that Handset 15 is busy. Instead of announcing to
Line 4 that Handset 15 is busy, the base sends an alert to Handset 15.
4. Upon receiving the alert, the handset sounds an audible double beep alert and
LCD displays “New call on Line 4”.
5. Handset 15 can:
a. Ignore the new call; continue talking to Line 1.
b. Press Switch key to switch to Line 4.
c. Subsequent pressing of FLASH key will toggle between Line 1 and Line 4.
d. Press key while talking to a line will terminate that particular call and
automatically switch back to talking to the remaining line.
Notes:
1. This built-in call waiting is separate from the Call Waiting feature available from