Press number 9 , this will enter administration menu.
Press number 2 , handset enters Line setting menu.
Enter Base ID(00~07) to access base.
Press 1 to enter Broadcast setting
i. Press or to select L3 or L4 (the status of setting
will be displayed on LCD)
ii. Press CHANGE to enter the setting mode, and the base ID
will be displayed on LCD.
iii. Press On (Left soft key) to enable the broadcast function.
Press Off (Right soft key) to disable the broadcast function.
iv. After setting broadcast, press On (Left soft key) to enable
the AA. Press Off (Right soft key) to disable the AA. This AA
will prompt a greeting message to enter a two-digit
number (“01” ~ “07” for Group ID: “10” ~ “99” for Handset
ID: “00” for all).
Re: L3 and L4 can be setting as two broadcast lines, repeated
above items for setting 2nd broadcast line.
When calling through the line 3 or 4, the caller will be prompt ed
by the greeting message to enter a two-digit extension number
( “01” ~ “07” for Group ID: “10” ~ “99” for Handset ID: “00” for all).
The greeting message : “Please enter broadcast ID or wait for
a tone to page all”
If there is no entry after 5 seconds, the broadcast will be
enabled to all handsets.
Note：
1. Line 3 and/or 4 can be reserved for broadcast function.
2. When enable the broadcast function, each line (either Line 3 or 4)
will take two time slots for one single call.
3. When configuring a base with a single broadcast port (e.g. line 3),
the feasible simultaneous call will be line 1, line 2 and line 3, the
line 4 will not be able to make or receive call.
4. When configuring a base with dual broadcast ports, if line 3 and 4
are making broadcast, at the same time, the line 1 and line 2 are no
longer to make or receive calls.
5. Broadcast is limited to 30 seconds.
To Next Page
Loading...
