Select a data rate from the drop-down list. The data rate affects throughput. If you select a low
data rate value, for example, the throughput is reduced but the transmission distance increases.
Transmit Power Set the power output of the wireless signal.
RTS/CTS Threshold Specify the threshold package size for RTC/CTS. A small number causes RTS/CTS packets to be
sent more often and consumes more bandwidth.
Specify the distance between Access Points and clients. Longer distances may drop high-speed
Sets the time that the receiver waits for RF reflections to settle out before sampling data. Using a
short (400ns) guard interval can increase throughput, but can also increase error rate in some
installations due to increased sensitivity to radio-frequency reflections. Select the option that
works best for your installation.
Merges data packets into one packet. This option reduces the number of packets, but increases
packet sizes.
Wireless Traffic
Shaping
Check this option to enable wireless traffic shaping. Traffic shaping regulates the flow of packets
leaving an interface to deliver improved Quality of Service.
Specify the wireless transmission speed used for downloading.
Outgoing Traffic Limit Specify the wireless transmission speed used for uploading.
Accept / Cancel Click [Accept] to confirm the changes or [Cancel] to cancel and return previous settings.
To Next Page
Loading...
