EnGenius ENS202EXT - Configuring Wireless MAC Filter

BASIC NETWORK SETTINGS CONFIGURING WIRELESS MAC FILTER
4-37
4.4.3 Configuring Wireless MAC Filter
Wireless MAC Filters are used to allow or deny network access to wireless clients according to their MAC addresses. You can manu-
ally add a MAC address to restrict the permission to access ENS202EXT. The default setting is Disable Wireless MAC Filters.
ACL Mode Determines whether network access is granted or denied to clients whose MAC addresses appear in the MAC Address
table on this page. Choices are Disable, Deny MAC in the list, or Allow MAC in the list.
MAC Address Filter Enter the MAC address of the device.
Click Add to add the MAC address to the MAC Address table.
Click Apply to apply the changes.
Note:
This section applies to Access Point and WDS Access point mode.