C146200300.fm
- 8 -
– The dispenser must be used as per projected purpose only. Improper use or misuse
may result into risky conditions and economic damages.
– When operating the dispenser, please ensure that there are no potential health and
safety hazards involved, particularly for children and disabled.
– Do not modify any device/component inside the dispenser. Any service not described in
this manual must be run by qualified personnel especially authorized by the Manufac-
turer. Use only original spare parts.
– Keep the dispenser in perfect duty conditions and run operations described in this man-
ual. A good maintenance will permit to keep the dispenser fully performing for long time
and to maintain high safety standards.
– Never wash the dispenser or lead water jets towards external or internal parts of it; that
is to avoid electronic device failures and/or damages.
Never run any maintenance service if the dispenser is electrically supplied, but prior re-
move the electric supply cord. Make sure it will remain unplugged till the end of the serv-
ice.
– Electric cord must be carefully dropped to avoid person hindrance, hot surfaces near-
ness or general damages.
– Do not operate the dispenser in case of damaged plug or electric cord.
– Never clean the dispenser with corrosive products or abrasive materials.
– Never connect electrical cord if dispenser electrical features don't match supplied volt-
age/frequency/power values and laws.
– Before leaving and after having left the dispenser out of duty for long time always run
maintenance operations to grant hygienic conditions.
– Never install the dispenser in critic environment, as explosion or fire risk, next to heat
sources or food contamination rooms. The dispenser doesn't have to be exposed to any
atmospheric agents or to corrosive exhalations.
To Next Page
Loading...