C146200300.fm
- 3 -
DISPENSER AND MANUFACTURER IDENTIFICATION
The shown identification label is available di-
rectly on the dispenser (one at the back, an-
other close to drip tray). That label resumes
identification data as model and serial
number, and all the information to start the
dispenser up in safety conditions.
A) Manufacturer identification
B) Mark: reference country compliance ini-
tials
C) Model/ Serial number
D) Manufacturing date
E) Voltage and frequency
F) Electrical power installed
G) Protection rate
H) Class category
L) Fuse characteristics.
M) Electric and electronic equipment ref-
erence (Law 2002/96 CE)
N) Reminder advising to consult operative instructions
SERVICE REQUEST
In case of need please refer to ENOMATIC service team or to authorized technicians only.
Should service be required, please always provide identification data printed on the label
and occurred malfunctions.
ATTACHED DOCUMENTS
Attached to this manual, listed documentation is provided.
– Declaration CE of compliance
– Warranty statement
– Poured bottles tracking chart
To Next Page
Loading...