C146200300.fm
- 19 -
6. Touch one of buttons (1-2-3) related to
dispensing tap where desired wine is en-
gaged to pour requested volume.
Illustration shows buttons to pour requested
doses.
1) Volume "taste"
2) Volume "half glass"
3) Volume "full glass"
Press desired button and release when pour
starts.
Pour ends when configured volume is dis-
pensed.
7. When pour is finished, wait for a few sec-
ond and then remove the glass from the
spout (G)
WINE BOTTLE REPLACEMENT
When a bottle replacement is required, act as
per instruction.
1. Quickly tap buttons (1-3) in sequence "1-
3-1" to completely lower the cylinder.
When the cylinder is lowered, buttons
turn off.
2. Open the door.
3. Remove the bottle from the straw and re-
place it with the same type of wine.
Bottles to be engaged must be at same
pouring temperature (±1 °C tolerance).
Bottles must be quickly removed and en-
gaged to reduce cooled air waste.
– A small quantity of wine will remain Inside
straw. It will mix with next bottle wine.
In case a different type of wine will be engaged, remove the straw from dispensing
tap and flush it under water or replace it to avoid different wines' mix.
To Next Page
Loading...