C146200300.fm
- 14 -
3. Connect gas supply pipes to relative inlets.
4. Correct the stance of the dispenser acting on adjustable feet to ensure proper working
condition.
5. Check dispenser stability and, if necessary, ensure it to the wall fixing provided holders.
6. Plug the electrical supply cord to the device.
Before plugging the cord to the electrical socket, turn main switch to OFF position
and make sure to provide voltage/frequency/power values as shown on identification
label.
7. Check dispenser working condition making sure to avoid flood leaks (air, nitrogen/ar-
gon, etc.).
To Next Page
Loading...