C146200300.fm
- 17 -
10. Insert the straw (E) into all dispensing
taps (F).
Straws must be completely inserted in or-
der to grant correct working condition.
11. Open the bottle you desire to engage.
12. Thoroughly clean bottle neck upper part
removing all foreign objects and ensuring
it is intact to provide correct sealing.
13. Insert the straw (E) into the bottle to en-
gage on bottle piston (C).
In case the bottle neck is further than 3cm
from dispensing tap, add one or two
spacers (D) inside bottle piston (C).
14. Check that filter straw reaches the bottom
of the bottle.
Should the wines feature sediments, snip
the straw to avoid the filter reaches the
bottom of the bottle.
15. Touch the button (2) to raise the cylinder
(C).
16. Bottle neck must properly fit the dispens-
ing tap adapter in order to avoid nitrogen/
argon leaks.
When the bottle is properly engaged, re-
lated buttons turn on.
Each dispensing tap buttons are off if the
bottle is not engaged.
17. Repeat the action to set one by one all the
bottles on piston to engage them into re-
lated dispensing tap.
To Next Page
Loading...