Use and maintenance manual
24 - MAINTENANCE
E5 Troubleshooting
FAILURE OR INCONVENIENCES
The control for the jacks activation does not work.
Lack of hydraulic oil
Hydraulic plant pipes damaged
A jack moves without the command for its activation
Air in the hydraulic circuit
Run the jacks in vain for a few minutes to drain the
air in the hydraulic circuit
Check the hydraulic oil level on the tractor.
Partial or inadequate forage harvesting
Teeth too distant from the ground
Adjust hay wheels weight (See paragraph D3)
Excessive vibration of a wheel around its axis
The wheel is not braked properly
Tighten the nut above the spring of the relating
register to properly adjust the wheel brake
To Next Page
Loading...
