enorossi RT7 - Introduction; A1 Information about the Hay Rakes; A2 Information about the Manual

Use and maintenance manual
INTRODUCTION - 5
INTRODUCTION
A1 Information about the hay rakes
The hay rake is an agricultural equipment used to collect any other type of previously cut forage. Our RT 7 – 9 are semi-mounted models and they are equipped
with a flexible and strong frame, for working on any type of soil, even on hilly ones. Each hay wheel (from 7 to 9) is independent from the others, because each one
is provided with a shock absorbing spring that allows it to follow the contours of the soil. The hay rake can work only if installed on any agricultural tractor equipped
with trailer hitch.
Its operation, besides to be hydraulic for the movement of arms and hay wheels, is obtained for effect of the trailing by the tractor to which it is attached.
Information more detailed about the rake operation is described in the relative chapter.
A2 Information about the manual
The company ENOROSSI (hereafter mentioned as “Manufacturer”) designed and built the equipment according to the appropriate safety rules with the precise
purpose to safe-guard both the personnel operating on the equipment that the whole operative system.
Every rake is supplied with a copy of this manual, which has to be read very carefully before using the machinery. In the manual are described the necessary
information about the transport, the use and the maintenance of the equipment as well as the relative safety rules.
The lacking in knowledge of the operational system may cause accidents, with consequent damages to the same equipment. Therefore, even if upon delivery the
Manufacturer supplies the Customer all information relating to the hay rake (functioning, use and maintenance), the Customer must read this manual and observe
the instructions therein.
The manual supplies the basic information for obtaining the best work and safety conditions but it remains the experience and good sense of the operator the most
important factor for the equipment functioning.
This manual was edited based on the current technical and constructive features of the hay rake and does not take into account similar products, produced
previously. However, the Manufacturer reserves the right to make modifications to the models in production, in order to improve its product or in case new relative
dispositions are issued (Machinery Directive), without the obligation of adjusting the previously manufactured models
This manual constitutes integrating part of the hay rake and, therefore, it must be well preserved, clean and intact in all its parts and kept in appropriate container,
placed on the equipment frame or inside the tractor cabin, ready for consultation. In case of transfer of the hay rake, it will be important to verify that the manual is
present in its case. In case it is lost, request a duplicate from the Manufacturer.
If during reading of the manual the instructions should be incomprehensible, contact the Manufacturer for the opportune clarifications. Should the manual be
translated in other language and part of its content present controversies, the valid text of reference remains that written in the Italian language.
Signals contained in the manual:
IMPORTANT
To signal the information must be known by the operator;