Ensitech TIG Brush - Preparation; Assembly; Classic Kit

16
TIG Brush™ Instruction Manual
2022
S4 OPERATION
PREPARATION
ASSEMBLY
4.1
4.2
CLASSIC KIT4.2.1
1. Inspect the TIG Brush Control Unit for any damage, and cables for exposed wire.
2. Ensure the Control Unit is dry.
3. Ensure the work environment is well ventilated and away from any
combustible substances.
4. Ensure the cables do not present a trip hazard.
5. Ensure there is ready access to clean water and a suitable area for washing.
6. After cleaning and/or polishing, to remove all acidic residue, wash down with
clean water, spray the cleaned area with the recommended Ensitech neutraliser,
and wash down again.
7. Wear suitable personal protective equipment as recommended in the SDS.
The minimum requirement is for gloves to protect hands from the fluid,
and goggles or safety glasses to prevent fluid splashing into the eyes.
Work piece
120V AC/230V AC*
Single phase
INSULATING SHROUD
MUST BE USED!
Wand
Shroud
Brush
*240V TBX models