4.3 CLEANING FLUID
Pour a small quantity of Weld Cleaning Fluid into the fluid jar. Place the fluid
jar close to the work because the tip of the brush will be dipped into the fluid
regularly during operation.
6. Attach Ground Cable plug to black Ground Cable Socket of the
TIG Brush Control Unit
7. Set POWER switch on the back of the machine to OFF
8. Attach Power Cord to the Power Socket on the back of the TIG Brush
Control Unit and plug into mains power
9. Attach the Ground Clamp to workpiece
19
TIG Brush™ Instruction Manual
Ensitech Pty Ltd
S4 OPERATION
To Next Page
Loading...