S7 CONSUMABLES
BRUSHES
INSULATING SHROUD
FLUIDS
7.1
7.2
7.3
The brush will wear down with use and should be replaced when
the bristles reach approximately 12mm (3/8”) in length.
Consumable supplies are available from authorised TIG Brush distributors.
The insulating shroud may become damaged or heat-affected.
If this happens, replacement shrouds should be purchased.
For optimum results, we recommend the use genuine Ensitech proprietary fluids.
Ensitech fluids are NSF certified and conform to the requirements of the NSF
Non-Food Compounds Registration Programme. The NSF mark is your assurance
that Ensitech pre, post and weld cleaning fluids have been tested and certified
by one of the most respected independent certification organisations.
Please check with your local TIG Brush distributor/dealer for details of fluids
available in your region or visit our website www.tigbrush.com
• Pre-Weld Cleaning Fluid: Aids in the removal of surface contaminants
prior to welding such as dirt, oil and residue of protective coatings and/or
cutting fluids to ensure a premium quality finish.
• Weld Cleaning Fluids: for cleaning, passivating and optionally,
polishing. (Biodegradable and pH Neutral fluids are available.)
• Neutralising Fluids: to ensure removal of all cleaning fluid residue, balance
the pH level of any residual fluid and prevent the occurrence of white frosting
caused by crystallization of residual acidic salts.
• Finishing Fluid: to provide a clean, bright and fingerprint resistant finish.
• Printing Fluid: can be used with custom or single-use stencils to print
on stainless steel.
• Engraving Fluid: also used with custom or single-use stencils to give a
deep custom engraving to stainless steel.
24
TIG Brush™ Instruction Manual
To Next Page
Loading...