S6 MAINTENANCE
MAINTENANCE
• When not in use, ensure the On/Off switch is OFF. This is confirmed
when neither the LED in the switch on the back, nor the Standby
LED in the front panel are illuminated.
•
•
At completion of a work shift, unscrew brush from Classic Wand,
Flexi Handle. Remove brush from the insulating Shroud and rinse
brush, Shroud and any part of the Classic Wand or Flexi Handle
that has come into contact with fluid, with clean water to remove
cleaning solution. Spray with neutralizing fluid (TB-42 when
using TB-25 or TB-21ND weld cleaning fluid, or TB-41 if using
TB-30ND weld cleaning fluid), then re-rinse. Allow to dry
before reassembling.
If using the PROPEL Torch, at the end of use, remove the Brush
and the Shroud and rinse with clean water. Rinse the Collet Assembly
and any part of the PROPEL Torch which may have cleaning fluid residue
on it after use. After rinsing components with clean water, spray with
neutralising fluid. Allow to dry before reassembling. See the PROPEL
Torch Instruction Manual for more detailed instruction on the
correct maintenance procedure for the PROPEL Torch.
• Rinse clamp with water to remove solution and prevent corrosion.
• Use a wet cloth to wipe fluid splashes off the TIG Brush Control Unit.
After some time splashes and marks may accumulate and become
difficult to remove.
Rinse brush
components
after use
Wand Brush
Remove brush from Wand
6.1
23
TIG Brush™ Instruction Manual
Ensitech Pty Ltd
To Next Page
Loading...