Ensitech TIG Brush - Troubleshooting; The Mains Power Button on the Back of the Control Unit Doesnt Operate Properly or Illuminate; The Front Panel Leds Are Not Illuminating; The Control Unit Is Making Ahumming;Buzzing Noise

26
TIG Brush™ Instruction Manual
2022
S8 TROUBLESHOOTING
THE MAINS POWER BUTTON ON THE BACK OF THE
CONTROL UNIT DOESN’T OPERATE PROPERLY
OR ILLUMINATE
8.1
If the TIG Brush is not operating correctly, please refer to the following trouble
shooting guide before contacting your TIG Brush distributor.
1. Check the power cord is firmly pushed into the Mains Power Socket
on the back of the Control Unit and the Power Point is turned on.
2. Check the power cord for any damage and replace if needed.
3. Check using another power point and power cord.
4. If the above fails to solve the problem, please contact your distributor,
dealer or Ensitech for instruction on how to return your TIG Brush
for assessment.
THE FRONT PANEL LEDs ARE NOT ILLUMINATING8.2
1. Check the power cord is securely pushed into the back of the Control
Unit and the Power Point is turned on.
THE CONTROL UNIT IS MAKING A
HUMMING/BUZZING NOISE
8.3
1. Try rotating each control knob through its positions quickly several times.
2. If the above fails to solve the problem, please contact your distributor, dealer
or Ensitech for instruction on how to return your TIG Brush for assessment.
2. Check the main rear power button is in the on position and is
illuminated red.
3. If the above fails to solve the problem, please contact your distributor,
dealer or Ensitech for instruction on how to return your TIG Brush
for assessment.