Enterasys G3G124-24 User Manual

Removing a Power Supply
Enterasys G-Series Hardware Installation Guide 2-9
6. Withthepowersupplyproperlyinsertedintotheopening,carefullyslidethemoduleuntilit
connectstothebackplane,asshowninFigure 2‐2onpage 2‐9.Themodule’shandleshouldbe
nearlyflushwiththebackoftheG‐Seriesswitch.Ifsignificantresistanceisencountered
beforethepowersupply
isseated,removeandreinsertit.Donotforcethemoduleintoplace.
Figure 2-2 Installing a Power Supply Module (1200-watt module into PWR 2 slot shown)
7. Securethepowersupplytothechassisbytighteningthecaptivescrews.
8. Ifyouareinstallinganadditionalpowersupply,repeatstep4throughstep7.Ifnot,ensure
thattheunusedpowerslothasacoverplate
installedoverit.
Removing a Power Supply
Toremoveapowersupply,proceedasfollows:
1. Attachananti‐staticwriststrapbeforehandlingthepowersupplymodule.
2. Unplugtheassociatedpowercordfromtheoutlet.
3. UnplugthepowercordfromtheACinlet(associatedwiththepowersupplyyouare
removing)atthebackofthechassis.
4. Unscrewthe
captivescrewstoreleasethepowersupplyfromthechassis.
5. Removethepowersupplybygraspingthehandleandpullingitstraightoutofthechassis.
6. Fastenacoverplateovertheemptyslot.
1 Power supply 2 Power supply handle 3 Captive screws
Caution: If you plan to operate the chassis with only one power supply, be sure to install the
coverplate in place of the removed power supply to contain EMI radiation and ensure proper air
circulation.
Precaución: Si desea trabajar sólo con una fuente de poder, no olvide colocar la tapa en el
compartimiento de la fuente de poder que haya eliminado, para reducir la interferencia
electromagnética y para asegurar una buena ventilación.

Enterasys G3G124-24 Specifications

General

Brand	Enterasys
Model	G3G124-24
Category	Network Router
Language	English