MAINTENANCE
Combin ation Blan ket/Flui d W armer ▪ Operat or’ s Manua l ▪ MN -399 40 ▪ Rev 3 ▪ 8/20
39
MAINTENANCE
Maintenance Schedule
Daily For daily maintenance, do the following.
Check:
▪ the air vents in the airflow insert panels are not obstructed (if applicable).
▪ all fan guards are clear and not obstructed (if applicable).
▪ the number of bottles/bags, or blankets as applicable do not exceed the
maximum capacity per shelf or basket.
Clean:
▪ any spills with a clean, lint free cloth. See topic How to Clean the Warmer for the list
of approved cleaners.
Monthly For monthly maintenance, do the following.
Check:
▪ the door gasket for tears and holes. Make sure that it is firmly attached to the
door. Check the seal when the door is closed.
▪ the guards around the air temperature sensor are in place and fully secure to the
warmer.
▪ the hardware securing the warmer(s) to the wall, if applicable.
Clean:
▪ the outside of the warmer with stainless steel cleaner. See topic How to Clean the
Warmer for the list of approved cleaners.
▪ vacuum (if applicable):
□ fan openings
□ fan sail switch
□ vent openings
Continued on next page
NOTE: Do not remove exterior panels from the warmer or attempt
repairs. The warmer has no user-serviceable internal components.
Only perform routine cleaning and maintenance procedures
specifically described in this manual.
To Next Page
Loading...
