Enthermics EC1850BL - How to Operate the Trimode Warmer (Top Cavity)

OPERATION
Combin ation Blan ket/Flui d W armer ▪ Operat or’ s Manua l ▪ MN -399 40 ▪ Rev 3 ▪ 8/20
31
How to Operate the TriMode Warmer
(Top Cavity)
Before you begin The warmer must be connected to electric power and turned on.
Procedure
To operate the warmer, do the following.
Step Action
1. Select the operation mode.
▪ Press the irrigation button for irrigation mode.
▪ Press the injection button for injection mode.
The selected operation mode will illuminate .
▪ Press the blanket button for blanket mode.
The blanket operation mode icon will not illuminate.
Continued on next page
WARNING: Personal injury hazard.
Do not operate the warmer in the presence of a flammable
anesthetic mixture with air, oxygen, or nitrous oxide; in
oxygen-enriched environments; or in any other potentially
explosive environment.
WARNING: Personal injury hazard.
Verify the fluid temperature prior to using the fluid. Refer to the
fluid manufacturer’s label for recommended warming
procedures.
Do not use any fluids that are warmed above the suggested
temperature.
NOTICE
Do not overload the cavity.
Refer to topic Specification Information for the storage cavity
capacity.

NOTE: Open the door to cool the cavity before changing
from a higher temperature to a lower temperature.