EasyManua.ls Logo

Entrematic Ditec DAS200HD - Page 39

Entrematic Ditec DAS200HD
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39
IP2266EN
EN
Side Presence Activation Distance (00÷99dm)
This is an inhibit signal for side presence.
The door will act according to the value entered in para-
meter 2A.
The value has to be according to local legislation. In an esca-
pe route the door has to open to 80% of the certified distance
(see parameter 11) within 3 sec. after an inner impulse.
00= If value 00 is selected side presence impulse is valid
from fully closed to fully open position.
01-99= The distance is counted from open position.
During opening, the side presence impulse is inhibited
until the door reaches the entered value in the parameter.
Sensor Type (00÷01)
Select type of monitoring for the combined sensors. Choose
between 1-wire (00) or 2-wire (01) monitoring.
00= 1-wire monitoring. 1-wire monitoring is used when
combined sensors have only one monitoring input for
both presence and impulse field.
01= 2-wire monitoring. 2-wire monitoring is used when a
sensor has separate monitoring inputs for both presence
and impulse field.
Active Brake on Stop (00÷01)
00= Off. The door will freewheel until it stops.
01= On. The operator will brake the doors actively during
1s on a Stop impulse.
Push & Go in EXIT and OFF Mode Selection (00÷01)
00= Off.
01= On.
Hold Force in EXIT and OFF Mode Selection (00÷01)
00= Off.
01= On.
With an electromechanical lock this hold force can be
unnecessary.
Toggle Operation Mode Seector after Stop (00÷01)
In operation mode selection OFF the mode must be changed
before normal operation after a Stop impulse.
00= Off.
01= On.
Emergency Action (00÷01)
Fire closing or Emergency opening.
00= Closing (The door will close on fire impulse or power failure).
01= Opening (The door will open on fire impulse or power failure).
NOTE: on this DAS200RG this display is not visible and is set to 01.
Emergency Action in OFF Mode (00÷01)
Decides if “Emergency Action” shall be performed also in
modes election OFF (= opens also in the middle of the night).
00= Off.
01= On.
NOTE: on this DAS200RG this display is not visible and is
set to 00.

Related product manuals