ENVIRO-TEC
17
REPLACEMENT PARTS
Factory replacement parts should be used wherever
possible to maintain the unit performance and
operating characteristics and the testing agency listings.
Replacement parts may be purchased through the local
Sales Representative.
Contact the local Sales Representative before attempting
any unit modications. Any modications not authorized
by the factory could result in personal injury and damage
to the unit and could void all factory warranties.
When ordering parts, the following information must be
supplied to ensure proper part identication:
1. Complete unit model number
2. Unit hand connection (right or left hand) while
facing the direction of airow at the inlet
3. Complete part description including any num-
bers
On warranty replacements, in addition to the information
previously listed, the project CO # that appears on the
unit nameplate, is required. Contact the factory for
authorization to return any parts such as defective parts
replaced in warranty. All shipments returned to the
factory MUST be marked with a Return Authorization
Number, which is provided by the factory.
All equipment and components sold through ENVIRO-
TEC are warranted under the same conditions as the
standard manufacturer’s warranty with the exception
that the warranty period is 12 months unless the
component is furnished as warranty replacement. Parts
furnished as warranty replacements are warranted for
the remaining term of the original unit warranties.
To Next Page
Loading...
Need help?
General
