Pulse oximeter MySign
®
S
8 Maintenance / cleaning
The unit is maintenance-free and therefore does not need to be inspected at specific intervals with regard to its
measuring function or safety. The unit automatically tests all of its functions every time it is switched on and will
show any faults it detects. The unit also continuously monitors all of its functions while operating.
Always check the unit, the sensor, the charging equipment and all cables for external damage before use.
The unit may only be serviced by EnviteC or service personnel that have been trained by EnviteC.
Repairs
In the unlikely event that your system will need to be repaired, please contact your dealer or send the system and
all of its accessories to the following address:
EnviteC-Wismar GmbH
Service
Alter Holzhafen 18
23966 Wismar, Germany
To speed up the repair process, please obtain an RMA (Return Material Authorization) number through our
website, www.envitec.com, under Service / Returns.
Please state your RMA number in all your correspondence!
Cleaning and disinfection of the MySign
®
S
Only perform a wipe disinfection by gently wiping the unit with a soft, disposable cloth soaked with isopropyl
alcohol.
Keep the battery cover closed when cleaning and disinfecting the unit! Do not allow moisture to enter
the unit. The electrical contacts inside the unit (battery) and at the USB port must be clean and dry
at all times to ensure that the unit will function properly.
Cleaning and disinfecting SpO2 sensors
Follow the instructions in the respective sensor operating manual.
The sensors should be cleaned and disinfected after every use on the patient in order to prevent
Do not put any mechanical stress (through pulling, stretching or twisting) onto the sensor cable.
066-07-1002197_GA_MySignS_FDA / 06.14 39
To Next Page
Loading...