36 / 48
6.11 Button functions
Recorder buttons have the following functions during long-term blood
pressure measurements:
is used too begin and end a measurement.
is used to display the most recent measured values or
the most recent error message.
is used to manually switch the measurement intervals
from the day to night phase, and vice versa.
Note:
You can only manually switch between day and night phase when 2
measurement intervals only have been programmed via the
PhysioQuantWin software when the starting sequence of the recorder
was commenced.
If more or less measurement intervals have been programmed, then the
Day/Night button has no effect on the measurement intervals.
To Next Page
Loading...
