3.4 Mounting
WARNING: Risk of explosion! Never install the controller in a sealed enclose
with flooded batteries! Do not install the controller in a confined area where
battery gas can accumulate.
WARNING: Risk of electric shock! When wiring the solar modules, the PV
array can produce a high open-circuit voltage, so turn off the breaker before
wiring and be careful when wiring.
CAUTION: The controller requires at least 150mm of clearance above and
below for proper airflow. Ventilation is highly recommended if mounted in an
enclosure.
Installation Procedure:
Step 1: Determine the installation location and heat-dissipation space
The controller requires at least 150mm of clearance above and below for proper
airflow, shows as below figure.
To Next Page
Loading...
Need help?
General
