Epever MPPT User Manual

5
 Support the lead-acid and lithium batteries, programmable temperature
compensation
 High temperature charging automatic power reduction function
 The freely set voltage level of the two-way load output, especially suitable for
voltage-sensitive loads
 Configurable cut-off voltage value for the two-way load output
 Support no-battery mode, PV array powers the load directly ①
 High-efficiency buck-boost control chip and power device, conversion
efficiency up to 98.9%
 Optional charging prior mode and load prior mode
 Effectively prolong the running time of load one by the discontinuous power
supply in load prior mode
 Customized the load two output according to the actual requirement
 Common negative design, used in a negative grounded system
 Real-time monitor controller by an external remote meter, BT module, Wifi
module or PC software
 Comprehensive electronic protections
① Set the rated voltage level of the battery to auto recognition mode through the PC software or the
remote meter, and the controller will be in no-battery mode.

Epever MPPT Specifications

General

Display	LCD
Type	Solar Charge Controller
Nominal System Voltage	12V/24V Auto (depending on the model)
Max Charging Current	10A to 40A (depending on the model e.g., 10A for Tracer1210AN)
Communication	RS485
Rated Battery Voltage	12V/24V Auto
Protection Features	Over Voltage, Reverse Polarity, Over Discharge, Over Heating, Over Load
Efficiency	Up to 98%
Dimensions	Varies with model.
Model	Tracer AN series (e.g., Tracer1210AN, Tracer2210AN, Tracer3210AN, Tracer4210AN, Tracer1215AN, Tracer2215AN, Tracer3215AN, Tracer4215AN)