❏ If you move a developer cartridge from a cool to a warm environment, wait for at least one
hour before installing it to prevent damage from condensation.
w
Warning:
❏ Do not touch the toner in developer cartridges. Always keep toner away from your eyes. If
toner gets on your skin or clothes, wash it off with soap and water immediately.
❏ Keep developer cartridges out of the reach of children.
❏ Do not dispose of used developer cartridges in fire, as they may explode and cause injury.
Dispose of them according to local regulations.
❏ If toner is spilled, use a broom and dustpan or a damp cloth with soap and water to clean it
up. Because the fine particles can cause a fire or explosion if they come into contact with a
spark, do not use a vacuum cleaner.
Replacing the developer cartridge
Follow these steps to replace the developer cartridge:
Note:
❏ The developer cartridge is not an independent unit that you install directly into the printer. The
cartridge needs to be inserted into the photoconductor unit’s casing and then installed into the
printer.
❏ The illustrations used in this procedure show the EPL-6200.
1. Lower the printer’s output tray.
EPSON AcuLaser M1200 Series User’s Guide
Replacing Consumable Products 70
To Next Page
Loading...
