8. Hold the photoconductor unit’s casing by its handle and insert it into the printer. Slide it
gently into the opening until it locks into place.
9. Close the front cover until it clicks shut.
Whenever you replace the developer cartridge, you should also clean the paper roller as described
in “Cleaning the paper path rollers” on page 83.
Photoconductor Unit
Always observe the following handling precautions when replacing photoconductor units:
❏ When replacing the photoconductor unit, avoid exposing it to room light any longer than
necessary.
❏ Be careful not to scratch the surface of the drum. Also, avoid touching the drum, since oil from
your skin may permanently damage its surface and affect print quality.
EPSON AcuLaser M1200 Series User’s Guide
Replacing Consumable Products 74
To Next Page
Loading...
