❏ To get the best print quality, do not store the photoconductor unit in an area subject to direct
sunlight, dust, salty air, or corrosive gases (such as ammonia). Avoid locations subject to
extreme or rapid changes in temperature or humidity.
❏ Do not tilt the photoconductor unit.
w
Warning:
❏ Do not dispose of the used photoconductor units in fire, as it may explode and cause injury.
Dispose of it according to local regulations.
❏ Keep photoconductor units out of the reach of children.
Replacing the photoconductor unit
Follow these steps to replace the photoconductor unit:
Note:
❏ The photoconductor unit is not an independent unit that you install directly into the printer. The
unit also houses the developer cartridge in its casing, and therefore, requires that the developer
cartridge be temporarily removed when you need to replace the photoconductor unit.
❏ The illustrations used in this procedure show the EPL-6200.
1. Lower the printer’s output tray.
EPSON AcuLaser M1200 Series User’s Guide
Replacing Consumable Products 75
To Next Page
Loading...
